As it was a good day, and over the next few days the temperature is supposed
to drop down to 10 degrees C. I made a start on the wiring loom removing the
adapter and the voyager ecu plugs, and at the same time connecting the
intrepid ecu plugs.
This how I left the wiring at 2pm to go do some errands and get supplies. The
wiring is correctly put together temporally.
I made a start on soldering each connection and using heat shrink isolation
over the joins and to isolate the odd not needed wire.
To give you an idea this half way through the soldering.
I need to apply heat to about 7 of the wires tomorrow to finish off the change
over of the plugs. I stopped only because the light was going and my back and
legs already had! The worst bit is done now as it would have been worse for me
to do it in colder weather.
During the process of checking the plug wiring I noticed something that makes
me think I screwed up or something! There are 2 separate wires for fan relay
control. So I may have had it connected to the wrong one?
(pm your email address if you want to see the connecter wiring details
so somebody else can check my wiring please)
There is still a fair bit of wiring to sort out, solder and tidy up in that corner of
the engine bay! But with sitting hunched over the engine bay, I have done
myself a mischief, so tomorrow I will be taking it easy.
)