Early Javelin Restoration

[Ian]

That is awesome work. I have always loved Jowetts tho sadly you really don't see that many any more which makes your restoration even more unusual. Top work

[UKJeeper]

Nice write up/blog. Lot of love going into that car.



(though i was expecting the thread to be about an AMC Javelin! )

[JPB]

.......AMC Javelin!

A what now?

[Grumpy Northener]

Thanks for comments guys - much appreciated - onward progress as of yesterday

WP_20130505_001-002.jpg (68.44 KiB) Viewed 2031 times

Lower section of the D post made up and welded in

WP_20130505_002-002.jpg (62.89 KiB) Viewed 2031 times

Closing panel at the bottom of the inner wing / wheel arch in the making / trial fitted

[Grumpy Northener]

WP_20130505_003-002.jpg (66.8 KiB) Viewed 2031 times

Welded in - mig on the seams and spot welded on the flange edges & where the two skins are flush

WP_20130505_004-002.jpg (65.1 KiB) Viewed 2031 times

Just a closing panel to make up between the bottom of the wheel arch & the D post -once this is complete the out rigger can be attached

[Grumpy Northener]

Closing panel made up and tacked

WP_20130511_002.jpg (71.18 KiB) Viewed 2009 times

Outrigger in final trial fitting

WP_20130511_003.jpg (71.15 KiB) Viewed 2009 times

[Grumpy Northener]

Outrigger now in place - flanges to edge of D post and sill were spot welded to match factory methods of assembly - closing section for end of outrigger made up and final welding of area completed

WP_20130511_004.jpg (66.48 KiB) Viewed 2009 times

Cleaned up

WP_20130511_005.jpg (66.17 KiB) Viewed 2009 times

[Grumpy Northener]

A small area of the inner wing had rotted out adjacent to the rear suspension mounting - water ingress had found its way down from the quarter glass in the rear wing and been held in this area forming a well - in turn the metal corroded from the inside out

WP_20130511_006.jpg (79.56 KiB) Viewed 2009 times

Repair completed with new metal let in

WP_20130511_007.jpg (68.43 KiB) Viewed 2009 times

[Grumpy Northener]

Next was the O/S 'D' post

WP_20130511_008.jpg (59.53 KiB) Viewed 2009 times

Which was quite weak in some areas

WP_20130511_009.jpg (57.81 KiB) Viewed 2009 times

[Grumpy Northener]

Effected metal cut out , new sections fabricated and let in

WP_20130511_010.jpg (66.35 KiB) Viewed 2007 times

Cleaned up

WP_20130511_011.jpg (64.13 KiB) Viewed 2007 times

Completed

WP_20130511_013.jpg (67.99 KiB) Viewed 2007 times

We are just contemplating making up a trolley to mount the shell so that we can remove from the workshop and get it on to a trailer - we would like to exhibit it at our national rally in a couple of weeks time (25th & 26th May) see listing in events / meets / local clubs section - just gives everyone an insight into how much work is involved in a full restoration.