Engine mount refurbisher anyone?

Post your technical queries / problems here!
Post Reply
Message
Author
User avatar
Minxy
Posts: 547
Joined: Fri Jan 07, 2011 9:29 pm
Location: West Northamptonshire

Engine mount refurbisher anyone?

#1 Post by Minxy » Wed Aug 03, 2016 3:09 pm

I have been getting stuck into the Lanchester now I am on school holiday. The rad is off for a refurb and the water pump. Now while I have been stripping the front out it soon became obvious that the engine mount was showing its age and in turn letting the front of the engine sag, now it's apart I can see that it's well past its best. Now things like this are unobtainable, there is a 'repair' that is commonly used involving Cortina axle bushes but I would rather get it done properly so does anyone know of a company that can re-metalastic mountings? I have searched and there are plenty of suppliers of mounts but I'm struggling to find anyone that will rebuild an existing mount.
Never play chess with a pigeon. It will knock all the pieces over, S*#t on the board and then strut around pretending it won.

Post Reply

Who is online

Users browsing this forum: No registered users and 12 guests