Jensen Interceptor, with a twist
Posted: Wed Apr 30, 2014 10:57 am
This thread is intended to be the story of this whole build. Inspired by the Jensen Viperceptor we wanted to make a modern looking Jensen, but still use the original engine and gearbox and also give the car subtle engineering upgrades.
Both front and rear arches have been flared, the stainless trim at the bottom has also gone and replaced by metal.
Hand made front valance, looks the same as the original just deeper.
Hand made headlight surrounds.
Yes, they are Dodge Challenger Headlights. A whole new grill will need to be made, also undecided on whether to put a wire mesh in the front valance or grill slats to match the grill?
We were going to use Chrysler 300C headlights, however, they just didn't seem to go with the front end plus they looked too big.
Both front and rear arches have been flared, the stainless trim at the bottom has also gone and replaced by metal.
Hand made front valance, looks the same as the original just deeper.
Hand made headlight surrounds.
Yes, they are Dodge Challenger Headlights. A whole new grill will need to be made, also undecided on whether to put a wire mesh in the front valance or grill slats to match the grill?
We were going to use Chrysler 300C headlights, however, they just didn't seem to go with the front end plus they looked too big.