Page 4 of 4
Re: MGB GT 2.8 V6
Posted: Fri Sep 13, 2013 8:15 am
by crabo249
Finally got all the panels on , still a bit of gap adjustment to sort out
Took her out into the sunshine for a couple of photo's
- photo 1.JPG (67.69 KiB) Viewed 2878 times
- photo 2.JPG (74.46 KiB) Viewed 2878 times
- photo 3.JPG (75.13 KiB) Viewed 2878 times
Re: MGB GT 2.8 V6
Posted: Fri Sep 13, 2013 8:23 am
by crabo249
Started fitting the interior , hope to be completed by the weekend
- Headlining finished
- Rebuild September 004.JPG (100.4 KiB) Viewed 2877 times
- Started fitting carpets
- Rebuild September 001.JPG (95.87 KiB) Viewed 2877 times
- Rear seat fitted
- Rebuild September 007.JPG (102.35 KiB) Viewed 2877 times
Hope to have the windscreen and tailgate fitted by next week , still a few electrical jobs to do then it's off for MOT
Re: MGB GT 2.8 V6
Posted: Fri Sep 13, 2013 9:57 am
by Richard Moss
Looking good - although the bonnet scoop isn't entirely to my taste
Re: MGB GT 2.8 V6
Posted: Sat Sep 14, 2013 9:10 am
by 3xpendable
Great job there
I'm not far from you actually, where did you get the silver soundproofing?
Re: MGB GT 2.8 V6
Posted: Sat Sep 14, 2013 7:19 pm
by crabo249
I got the soundproofing from ebay , they are @ 10"x8" self adhesive panels
The bonnet scoop is there because the engine sits a little higher than I had planned , so a job for the future is to lower it by a couple of inches and replace the bonnet with one without a scoop
Re: MGB GT 2.8 V6
Posted: Sat Sep 14, 2013 8:06 pm
by rich.
would an rv8 bonnet help?
Re: MGB GT 2.8 V6
Posted: Sat Jan 17, 2015 3:28 pm
by stevmale
Has the project been sucessful .
Has i am considering converting my mgb roadster.
With a ex scimitar 2.8 unit I have.
Thanks.
steve